The main parameters .SY-LASER-

X,Y working range: 1300mm*2500mm

Cutting focusing lens: F=80mm

Maximum laser output power: 500W

Adjust the frequency of subsequent punching: $300Hz

Power pulse width: 0.5ms-2ms

Laser: double – lamp gold – plated concentrating cavity

Cutting interface card: CNC 3000 control card

Cutting software: suitable for PLT, DXF format

Refrigeration power: 4W

Repeat positioning accuracy: ±0.03/300mm

Idle speed: 0-20000mm/min

Cutting speed: 0-15000mm/min

Cutting quality

Cutting precision is the first factor to judge the quality of CNC laser cutting machine. Four factors affecting the cutting accuracy of CNC laser cutting machine:

1, laser generator laser condensation size. After gathering if the light spot is very small, the cutting accuracy is very high, if the gap after cutting is very small. The precision of laser cutting machine is very high, the quality is very high. But the laser beam is tapered, so the cut gap is also tapered. Under such conditions, the greater the thickness of the workpiece, the lower the accuracy will be, so the greater the slit.

2, the accuracy of the workbench. If the precision of the table is very high, the precision of the cutting is also improved. So the accuracy of the table is also a very important factor to measure the accuracy of the laser generator.

The laser beam condenses into a cone. When cutting, the laser beam is conical down, then if the thickness of the cutting workpiece is very large, the precision of cutting will be reduced, and the gap will be very large.

4, cutting materials are different, will also affect the accuracy of laser cutting machine. In the same case, the precision of cutting stainless steel and aluminum will be very different, the precision of stainless steel cutting will be higher, and the section will be smooth.

Generally speaking, laser cutting quality can be measured by the following 6 standards.

1. Cutting surface roughness Rz

2. Notch hanging slag size

3. Trimming perpendicularity and slope U

4. Cut edge fillet size R

5. Stripe drag n

Post time: Oct-14-2021